You will need:
- Comb
- Water
- Hair gel
- Hair grips
- Cling film
- Sellotape
- Permanent marker pen
- Wet the front of the models hair and use a comb to bring back the hair and make it as flat as possible so that you can clearly see the hairline.
- Consider the parting of the wig you are making a cast for.
- Gel the hairline into place and then use pins to secure it.
- Get a piece of cling film and place it over your models head and forehead and pull it tightly towards the back of the head. Make sure the cling film covers the models side burns.
- Then, stick sellotape onto of the cling film over the forehead, hairline and above the hairline of your model. Do a few layers so the cast is quite solid. You must cover the whole area that you are taking the cast from.
- Then use a permanent marker and trace over the hairline, drawing in the directions of the hair.
- Write the models name on the cast and then cover any permanent marker with more sellotape so it does not transfer onto the wig when you are making it.
- Put cast onto wig block and secure with sellotape and pins.
- For the hairline, the wig lace holes need to be going horizontal.
- Place the lace further down than the end of the cast, tightly placing the pins in the pattern of middle, middle, side side.
- Make sure the lace is flat on the hairline and then pleat it further back and pin tightly.
No comments:
Post a Comment